I recently moved to shared housing and they have a very poor Wifi 4 router located quite far from my room (no chance of wiring ethernet). As I’d like to host some (local) services for myself, I brought a Tp-Link Archer C6 (v3.2) with me to mess with. I had set up WDS successfully on the stock firmware to get a much better internet connection in my room, but it was finnicky and sometimes drop out entirely for hours. As I knew my router has good support from OpenWrt, I decided to flash it tonight and “quicky re-do the WDS setup”. It’s been over 5 hours and I’ve had no luck getting it to connect following the wiki’s guide. I also tried making a relayd-based access point, but it doesn’t seem to route to ethernet and when I tried connecting with my phone it just stays on “Obtaining IP address…”
I feel very much out of my depth… is there an easier way to achieve this? Basically, my ideal end result would be having a better/more consistent wifi connection (which I think works because the router has much stronger antennae than my laptop or phone) and ethernet, with OpenWrt available to toy with and learn more about networking.
I’ve always thought the firewall color codes were arbitrary, though I might just have not paid attention all these years lol.
Just to clarify: I meant connect your OpenWRT device to your hotspot instead of the AP you’ve been working with. Just to rule out multiple MACs being blocked on the AP.
Beyond that, I’m not really able to help troubleshoot further, but worst case and if all you need is internet, you can set your OpenWRT device up so that it just NATs your downstream connections. Double-NAT, in most cases, is fine.